I just can’t get enough of the Big Vintage Sewalong selection so have made a second, full skirted dress, this time from Vogue 2093. It has a choice of wide V-neckline or a fuller yoke to make the neckline less open (and for me, more suitable for day wear).
The princess seaming on the dress and skirt made this easier to fit as I could just add a little to the seamlines of the fronts and side fronts to accommodate my fuller bust – the easiest way to increase the bustline on this type of dress. Having taken my bust measurements and compared then with the finished garment measurements, I divided the difference between the four pattern edges (side front 2, centre front x 2) and added that amount just at the point I needed to. Then, I pinned the pieces together rand tissue fitted to check before cutting into my fabric.
The trickiest part of the dress is the yoke, facing and sleeves so it is worth reading the construction notes carefully in advance before tackling this. The sleeves are set in, but only partially stitched to the dress at the under arm, then to the facing/yoke. It does all come together, but needs bold clipping and lots of pinning to get the pieces together smoothly. I also took out quite a large section at the back to fit my narrow back.
I also did some understitching on the facing to hold it neatly in place and preventing it rolling out. To do this, stitch the facing to the garment right sides together, trim seam allowances and press them towards the facing. Then open out facing away from the garment and stitch on the facing, close to the previous seam line, catching the seam allowances in place as you go. I tend to work with the wrong side uppermost so I can see the seam allowances although patterns tend to tell you to stitch with the facing right side uppermost.
All zipped Up
I love the way the zip in the centre back seam doesn’t go to the top – it is inserted a little way down as the neckline is wide enough to fit over the head, so it doesn’t need to zip right up. This means that you have a lovely neat top and avoid any difficulties with matching the top edges! I did choose to insert an invisible zip as is my preference, which meant sewing the zip in before completing the centre back seam (I’ll blog my super fast invisible zip insertion method another day). Also I didn’t have the right zip length to do so, so shortened it – see below!
To shorten the zip
To shorten a zip, simple mark the position you want the zip to end then bar tack stitch across, by stitching over and over again at the mark to create a new stop. Then cut off the rest of the zip, leaving about 1.5cm zip tape as you normally get on a zip. I also cut out the unwanted teeth below my new bar stop.
The skirt on this dress is very, very full, which means it has a curved hemline. Also it definitely needed to be hung for 24 hours before hemming as the side seams did droop (they are bias cut) so I then straightened the hemline before ease stitching 6mm from the edge. Next step was to turn up a narrow 13mm hem allowance, pulling up the ease stitching a little to gently ease in the fullness of the circular hem. I then tucked the raw edge and ease stitching in towards the first fold, pressed and pinned ready to top stitch from the right side. Voila, a lovely neatly turned up curved hem without ripples or gathers.